Indesit Washing Machine Door Lock Light Not Working

Your engineer will check for blockages in the pump filter waste hose and all plumbing under the sink.

Indesit washing machine door lock light not working.

Inspect the door lock for damage. Door locked appliance not starting 1. After a few seconds all the cycle lights come on green apart from the end light but it beeps and the lock light flashes red. This means that the door may not open.

Slacken the cap a little to drain the water. When i press start the wash light comes on green but the wash does not start. If the door lock is damaged or does not latch properly. Most washing machine wiring is in series that is the door interlock and the motor has to communicate.

Indesit iwd7145s washing machine lock light flashes when closed and will not wash. Before trying to manually unlock the door you can unplug the washer for 1 to 2 minutes or simply flip the breaker off. The door lock can fail either mechanically or electrically. Clean out any debris in there.

Probably not the problem then if it s below zero inlet outlet pipes to the machine can freeze which could mean it not working and various warning lights flashing this discussion has been closed. Tighten the cap to stop the water when you need to empty the container. The instruction printed below the light states press hold button for 3 seconds to unlock. Of course that doesn t work.

Unplug the washer from the wall and pull it forward. The door lock secures the washer door shut during operation. However if this doesn t work you can always manually open the door. Once the washer door is closed the washer can begin operating.

Check to see if the door is locked but the program is not starting or the door is electrically locked the door lock light does not come if this is the situation then there is a more possible chance that the wash motor brushes are worn or the wash motor itself is faulty. If the door lock is defective the washer door will not latch properly. Or if it does the water stays inside the drum. I unplugged the machine and plugged back on still won t unlock.

This usually helps the control panel reset and allows the door to unlock and the light to stop flashing. Once the machine is empty of water take the cap off.