How To Take A Deadbolt Lock Off A Door

Once the door is no longer connected to the frame you ll be able to slip it out of the opening and remove the lock from the interior side.

How to take a deadbolt lock off a door.

We used a schlage brand lock for this story. Each kit will re key six locks but you can order extra pins if you need to do more. To do this insert a flathead screwdriver under the. Take the door down if the unlikely eventuality you can t get the deadbolt to budge you can always take the door off its hinges.

The following instructions are kept super basic and simple to understand. The set plate will often be attached to the bolt and its sleeve and will slide out as one unit. Some deadbolts include a rose plate that adds a decorative touch to your hardware. Repair or replace it as needed.

If you have a need to remove a deadbolt from your door and can t seem to locate the mounting screws chances are that you need to remove the decorative rose plate. A note before installation. For the process you need to barely spare around ten minutes of your time and an inexpensive deadbolt lock. How to take a deadbolt off a door october 17 2019 october 4 2017 by lsf team you may need to remove a deadbolt off a door for a number of reasons such as changing the combination of the lock to keep unwanted visitors out or taking the lock off so the door can be painted.

To change a deadbolt lock start by unscrewing the old deadbolt and removing the interior and exterior faceplates. How to change a deadbolt lock on a door with minimal tool. But keep your current keys you ll need them to remove the cylinder. The kit will work on entrance and deadbolt locks and it comes with two keys and all the tools you ll need except a screwdriver.

If you have. Once you ve retracted the deadbolt and the door opens remove the two screws holding the lock mechanism to the door and pull it out. This rose plate also serves to cover the mounting screws so that they aren t visible. Remove the sliding bolt by turning the door to the narrow edge and locating the set plate which has two screws one on the top of the bolt s end and one below.

Remove the screws with a screwdriver.