How To Stucco A Concrete Wall

Stucco is made of four major components.

How to stucco a concrete wall.

After the bonding agent has been allowed to dry the stucco can be applied directly to the wall. Try to maintain a 1 16 to 1 8 depth when spreading the stucco on the wall. Apply the first coat. Make sure you apply the mix carefully covering entire surface with a thick coat.

The mixing ratio may vary depending on who you ask. Load stucco on a hawk and then take it on trowel for application. Work from the top and make your way down. Apply a coat of concrete bonding agent to the concrete surface using a paintbrush.

Use required pressure so as to press the mix into the wall as you go on applying it. To apply stucco to your existing brick block or concrete wall first brush a concrete bonding agent onto the wall. Apply the stucco mixture to the wall using a hawk and trowel or by spraying it on covering the entire wall. Use the trowel holding it at a slight angle to apply the plaster and the hawk or mortarboard to hold small amounts of plaster.

Get started with the application over the cinder wall using a trowel. Stucco a masonry or concrete wall 1. For one coat stucco systems apply quikrete one coat fiberglass reinforced stucco in a single application at inch thick. This will cover the voids and reduce the chances of the material sagging.

The stucco should be the consistency of a. Mix the stucco with water according to the packaging instructions. For our walls we used three parts sand one part lime and one part portland cement. How to apply stucco to concrete step 1.

After the mortar. Work from the bottom of the wall up and apply at a thickness of about 3 8 inch over the entire area. Portland cement sand lime and water. Step 10 screed the stucco to a uniform depth of 3 8 inch using a straight edge.

We add water until it is the consistency of brick mortar.