How To Strap A Roof For Metal Roofing

The gauge of the metal 24.

How to strap a roof for metal roofing.

Work up from the initial row starting at the lower corner in a diagonal pattern staggering the shingles to prevent gaps. Space the screws about 12 in 30 cm apart. Make sure that the screws are all aligned evenly as you will be able to see them from the ground if they are. Experienced do it yourselfers can use a nail gun with 8d nail clips instead of a hammer and nails.

This is not a complete install only basic install on a bungalow i. For exposed fasteners avoid over tightening the fastener. This is the starting point of the installation process. You are essentially sealing off the metal roof with this flashing and you need to make sure that is securely fastened.

Make sure to hook the bottom of the shingle into the bottom of the roof where there is an opening. Next you are ready to install the metal roof. You can use 1 inch nails for the installation of eave flashing. Most metal shingles will be attached to the roof using metal shingle.

The eave flashing or edging is just the steel metal strips used to cover the entire perimeter of the roof. 26 or 29 is a variable that must be considered as is the type of fastener and the pitch of the roof. Place one shingle at the bottom left or right of the roof. Use a tool belt that has a hammer loop to hold nails a measuring tape chalk line and a hammer when installing the wood.

Use a hammer to tap the shingle gently just to make sure it s securely in. When installing a metal roof over an existing roof before installing the. At a guess i would place the strapping no further apart than 16.