How To Reprogram Genie Garage Door Opener Remote

The light on the opener should blink and the garage door should open.

How to reprogram genie garage door opener remote.

This will lock in a new code and you will be able to use your remote controls normally. Place the ladder under the garage door power head and climb so you are within reach of the control buttons. Use the 2 curved rectangular buttons on the top half of the remote to reset and reprogram the opener. Repeat this process for each additional remote control you have.

The power head is attached to the ceiling of your garage. Press and release the learn code button on the receiver while the red led is blinking press your transmitter button 3 times. To reprogram your new and or existing remote controls. If your device was made between 1995 and 1997 then the remote button format will look a little different.

Just make sure you remember the button you pressed as this will be the button that opens and closes your garage door. Step 2 press and hold the learn button on the side of the power head for approximately 10 seconds or until the indicator light turns off. Programming your genie garage door remote is super easy. If not try the process again.